CLAAS MEDION 330/310 DOMINATOR 204/203 MEGA DOMINATOR VX 3rd cutterbar cylinder Fitting Instructions Manual_DE_EN_FR
DESCRIPTION:
CLAAS MEDION 330/310 DOMINATOR 204/203 MEGA DOMINATOR VX 3rd cutterbar cylinder Fitting Instructions Manual_DE_EN_FR
INTRODUCTION
These instructions describe the safe and timesaving work sequence for retrofitting the third cutterbar cylinder. Retrofitting of the MEDION 330/310, DOMINATOR VX, and DOMINATOR 204/203 combine harvesters, with the supplementary kit part no. 633 836.0, is possible from the following machine number ranges: 93200011, 92000011 and 93000011. The standard mounting time is approx. 1 man hour. See page 4.1 for the shipping package. Observe the »Safety Rules« in the applicable operator’s manual
General
information
IMPORTANT
- The instructions contained in this manual should be carefully read and observed by all persons who are concerned with the operation, maintenance and inspection of this machine/ front attachment in order to prevent accidents. Especially the »Safety Rules« in the operator’s manual should be read with the utmost care and adhered to. In addition, please also observe the accident prevention regulations that apply for your own country.
- Before commencing with the job, ensure that all the tools and service aids are available. Compare existing machine type/front attachment type with the list in the chapter »Shipping Package« and the parts kit supplied. The specification of the components, e.g. bolts, is shown on the shipping package.
- The shipping package shows the position number (pos. no.) of the components. Parts such as nuts and contact washers do not have a position number but belong to the bolt listed above which does have a position number. Additional part specifications are the parts no., description, measurements, DIN and the quantity. In order to help with the assembly,
- existing components in the instructions are identified with letters, whereas new parts have been identified with a number (position number). The text and pictures were kept neutral as far as possible. Differences between the individual types are mentioned in the text. Technical data, dimensions and weights are given as an indication only.
- CLAAS reserve the right to make changes subsequently as technical developments continue. Responsibility for errors or omissions not accepted. Front, rear, right and left refer to the direction of forward travel.
TABLE OF CONTENTS:
CLAAS MEDION 330/310 DOMINATOR 204/203 MEGA DOMINATOR VX 3rd cutterbar cylinder Fitting Instructions Manual_DE_EN_FR
CONTENTS
1 Introduction
Introduction 11
2 Contents
Contents 21
3 General information
Important 31
Identification of warnings and danger signs 32
Correct use 32
4 Shipping Package
Shipping Package 41
Supplementary kit 633 8360 41
5 Installation
Installing the third cutterbar cylinder 51
Preparing the installation 51
Installing the cutterbar cylinder 51
Preparing and performing the test run 53
IMAGES PREVIEW OF THE MANUAL:
PLEASE NOTE:
- This is the SAME exact manual used by your dealers to fix your vehicle.
- The same can be yours in the next 2-3 mins as you will be directed to the download page immediately after paying for the manual.
- Any queries / doubts regarding your purchase, please feel free to contact [email protected]
S.M